Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006FX35 AWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLBRAKE CONTROL SYSTEMTROUBLE DIAGNOSISDATA MONITOROPERATION PROCEDURE
2006 Infiniti FX35 AWD
Operation Procedure
2006 Infiniti FX35 AWDSECTION Operation Procedure
- After turning ignition switch OFF, perform "CONSULT-II Starting Procedure". Refer to "CONSULT-II START PROCEDURE ".
- Turn ignition switch ON.
- Touch "ABS""DATA MONITOR" in order on the CONSULT-II screen.CAUTION: When "START (NISSAN BASED VHCL)" is touched immediately after starting engine or turning on ignition switch"ABS" might not be displayed in the "SYSTEM SELECTION" screen. In this case, repeat the operation from step 1.
- Return to the Monitor Item Selection screen, and touch "ECU INPUT SIGNALS""MAIN SIGNALS" or "SELECTION FROM MENU". Refer to the following information.
- When "START" is touched, the data monitor screen is displayed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.