Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSINFINITI2006FX35 AWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLBRAKE CONTROL SYSTEMG SENSORREMOVAL AND INSTALLATIONREMOVAL

2006 Infiniti FX35 AWD

Removal and Installation: Removal

2006 Infiniti FX35 AWDSECTION Removal

Remove center console. Refer to CENTER CONSOLE .
Disconnect G sensor harness connector.
Remove G sensor mounting bolts. Then remove G sensor from vehicle.
CAUTION:
- Do not drop or strike G sensor, because it has little endurance to impact.
- Do not use power tool etc., because G sensor is weak for the impact.
  
  Fig 1: G Sensor Mounting Bolts With Torque Specifications
  Courtesy of NISSAN MOTOR CO., U.S.A.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.