Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSINFINITI2006FX35 AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMAUTO LIGHT SYSTEMSYMPTOM CHART

2006 Infiniti FX35 AWD

Symptom Chart

2006 Infiniti FX35 AWDSECTION Symptom Chart

SYMPTOM CHART

Trouble phenomenon

Malfunction system and reference

Parking, license plate, side marker and tail lamps and headlamps will not illuminate when outside of the vehicle becomes dark. (Lighting switch 1ST position and 2ND position operate normally.)
Parking, license plate, side marker and tail lamps and headlamp will not go out when outside of the vehicle becomes light. (Lighting switch 1ST position and 2nd position operate normally.)
Headlamps go out when outside of the vehicle becomes light, but parking lamps stay on.

Refer to "WORK SUPPORT ".
Refer to "LIGHTING SWITCH INSPECTION ".
Refer to "OPTICAL SENSOR SYSTEM INSPECTION ".

If above systems are normal, replace BCM.

Shut off delay feature will not operate.

CAN communication line inspection between BCM and combination meter. Refer to "CAN COMMUNICATION INSPECTION USING CONSULT-II (SELF-DIAGNOSIS) ".
Refer to "CHECK DOOR SWITCH ".

If above system is normal, replace BCM.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.