Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Vehicle Marks
2006 Infiniti FX35 AWDSECTION Vehicle Marks
SYMPTOM CHART
| Symptom | Possible cause | Possible solution |
|---|---|---|
| Names of roads and locations differ between plan view and BIRDVIEW™. | This is because the quantity of the displayed information is reduced so that the screen does not become difficult to read. There is also a chance that names of the roads or locations may be displayed several times, and the names appearing on the screen may be different because of a processing procedure. | This is not a malfunction. |
| The vehicle mark is not displayed in the correct position. | The vehicle was transported after the ignition switch was turned off, for example, by a ferry or car transporter. | Drive the vehicle for a while on a road where GPS signals can be received. |
| The position and direction of the vehicle mark may be incorrect depending on the driving environments and the levels of positioning accuracy of the navigation system. | This is not a malfunction. Drive the vehicle for a while to automatically correct the position and direction of the vehicle mark. | |
| When the vehicle is travelling on a new road, the vehicle mark is located on another road nearby. | The system automatically places the vehicle mark on the nearest available road, because the new road is not stored in the map data. | Updated road information will be included in the next version of the DVD-ROM. |
| The screen does not switch to the night screen even after turning on the headlights. | The daytime screen was set the last time the headlights were turned on. | Set the screen to the night screen mode using button when turning on the headlights. |
| The map does not scroll even when the vehicle is moving. | The current location map screen is not displayed. | Press the "MAP" button. |
| The vehicle mark is not displayed. | The current location map screen is not displayed. | Press the "MAP" button. |
| The GPS indicator on the screen remains gray. | GPS signals cannot be received depending on the vehicle location, such as in a parking garage, on a road that has numerous tall buildings, etc. | Drive on an open, straight road for a while. |
| A sufficient amount of GPS satellites is not available. | Please wait for the satellites to move to locations available for the navigation system. | |
| The location of the vehicle mark is misaligned from the actual position. | When using tire chains or replacing the tires, speed calculations based on the speed sensor may be incorrect. | Drive the vehicle for a while [at approximately 30 km/h (19 MPH) for about 30 minutes] to automatically correct the vehicle's mark position. If this does not correct the vehicle mark position, contact a NISSAN dealer or qualified workshop. |
| The map data has a mistake or is incomplete (the vehicle mark position is always misaligned in the same area). | Updated road information will be included in the next version of the DVD-ROM. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.