SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006FX35 AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESLAN SYSTEMTROUBLE DIAGNOSIS FOR SYSTEMSTEERING ANGLE SENSOR CIRCUIT INSPECTION
2006 Infiniti FX35 AWD

Steering Angle Sensor Circuit Inspection

2006 Infiniti FX35 AWDSECTION Steering Angle Sensor Circuit Inspection
  1. CHECK CONNECTOR 
    1. Turn ignition switch OFF.
    2. Disconnect the battery cable from the negative terminal.
    3. Check terminals and connector of steering angle sensor for damage, bend and loose connection (sensor side and harness side).

    OK or NG 

    OK : GO TO 2.

    NG : Repair terminal or connector.

  2. CHECK HARNESS FOR OPEN CIRCUIT 
    1. Disconnect steering angle sensor connector.
    2. Check resistance between steering angle sensor harness connector terminals.
      TERMINAL RESISTANCE CHART

      Steering angle sensor connector Terminals Resistance (Approx.)
      M14 4 5 54 - 66 Ω
      Fig 1: Identifying Resistance Between Steering Angle Sensor Harness Connector Terminals
      G04079049Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK : Replace steering angle sensor.

    NG : Repair harness between steering angle sensor and data link connector.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.