SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006FX35 AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESLAN SYSTEMTROUBLE DIAGNOSIS FOR SYSTEMAWD CONTROL UNIT CIRCUIT INSPECTION
2006 Infiniti FX35 AWD

AWD Control Unit Circuit Inspection

2006 Infiniti FX35 AWDSECTION AWD Control Unit Circuit Inspection
  1. CHECK CONNECTOR 
    1. Turn ignition switch OFF.
    2. Disconnect the battery cable from the negative terminal.
    3. Check terminals and connector of AWD control unit for damage, bend and loose connection (control unit side and harness side).

    OK or NG 

    OK : GO TO 2.

    NG : Repair terminal or connector.

  2. CHECK HARNESS FOR OPEN CIRCUIT 
    1. Disconnect AWD control unit connector.
    2. Check resistance between AWD control unit harness connector terminals.
      TERMINAL RESISTANCE CHART

      AWD control unit connector Terminals Resistance (Approx.)
      M92 8 16 54 - 66 Ω
      Fig 1: Identifying Resistance Between AWD Control Unit Harness Connector Terminals
      G04079044Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK : Replace AWD control unit.

    NG : Repair harness between AWD control unit and harness connector M82.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.