Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
ABS Actuator and Electric Unit (Control Unit) Circuit Inspection
2006 Infiniti FX35 AWDSECTION ABS Actuator and Electric Unit (Control Unit) Circuit Inspection
- CHECK CONNECTOR
- Turn ignition switch OFF.
- Disconnect the battery cable from the negative terminal.
- Check terminals and connector of ABS actuator and electric unit (control unit) for damage, bend and loose connection (control unit side and harness side).
OK or NG
OK : GO TO 2.
NG : Repair terminal or connector.
- CHECK HARNESS FOR OPEN CIRCUIT
- Disconnect ABS actuator and electric unit (control unit) connector.
- Check resistance between ABS actuator and electric unit (control unit) harness connector terminals.TERMINAL RESISTANCE CHART
ABS actuator and electric unit (control unit) connector Terminals Resistance (Approx.) E56 11 15 54 - 66 Ω
OK or NG
OK : Replace ABS actuator and electric unit (control unit).
NG : Repair harness between ABS actuator and electric unit (control unit) and harness connector E205.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.