SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006FX35 AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALMOTORS, SWITCHES, RELAYSPOWER SUPPLY, GROUND & CIRCUIT ELEMENTSIPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM)INSPECTION WITH CONSULT-II (SELF-DIAGNOSIS)
2006 Infiniti FX35 AWD

Inspection With CONSULT-II (Self-Diagnosis)

2006 Infiniti FX35 AWDSECTION Inspection With CONSULT-II (Self-Diagnosis)
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.
  1. CHECK SELF DIAGNOSTIC RESULT 
    1. Connect CONSULT-II and select "IPDM E/R" on the "SELECT SYSTEM" screen.
    2. Select "SELF-DIAG RESULTS" on the "SELECT DIAG MODE" screen.
    3. Check display content in self diagnostic results.
      SELF DIAGNOSTIC CHART

      CONSULT-II display CONSULT-II display code TIME Details of diagnosis result
      CRNT PAST
      NO DTC IS DETECTED. FURTHER TESTING MAY BE REQUIRED. - - - No malfunction
      CAN COMM CIRC U1000 x x Any of or several items below have errors.
      • TRANSMIT DIAG
      • ECM
      • BCM/SEC
      NOTE: The details for display of the period are as follows:
      • CRNT: Error currently detected with IPDM E/R.
      • PAST: Error detected in the past and memorized with IPDM E/R.

      Contents displayed 

      NO DTC IS DETECTED.FURTHER TESTING MAY BE REQUIRED. : INSPECTION END CAN COMM CIRC : "PRECAUTIONS WHEN USING CONSULT-II ".

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.