Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006FX35 AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALHORNSWIPER, WASHER & HORNFRONT WIPER AND WASHER SYSTEMFRONT WIPER DOES NOT STOP
2006 Infiniti FX35 AWD
Front Wiper Does Not Stop
2006 Infiniti FX35 AWDSECTION Front Wiper Does Not Stop
- CHECK CIRCUIT BETWEEN COMBINATION SWITCH AND BCM
With CONSULT-II
- Select "BCM" on CONSULT-II, and select "WIPER" on "SELECT TEST ITEM" screen.
- Select "DATA MONITOR" on "SELECT DIAG MODE" screen. Make sure that "FR WIPER INT""FR WIPER LOW""FR WIPER HI", and "FR WASHER SW" turn ON-OFF according to front wiper switch operation.
Without CONSULT-II
Refer to "COMBINATION SWITCH INSPECTION ".
OK or NG
OK : Replace IPDM E/R.
NG : Check combination switch (wiper switch). Refer to "COMBINATION SWITCH INSPECTION ".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.