Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006FX35 AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESWHEEL HUBSFRONT AXLEAWDFRONT DRIVE SHAFTREMOVAL AND INSTALLATION (RIGHT SIDE)REMOVAL
2006 Infiniti FX35 AWD
Removal and Installation (Right Side): Removal
2006 Infiniti FX35 AWDSECTION Removal
- Remove tires from vehicle with power tool.
- Remove undercover with power tool.
- Remove cotter pin. Then remove lock nut from drive shaft with power tool.
- Remove wheel sensor harness from strut assembly. Refer to
"WHEEL SENSORS
".CAUTION: Do not pull on wheel sensor harness.
- Remove brake hose lock prate. Then remove brake hose from strut assembly. Refer to "BRAKE TUBE AND HOSE ".
- Remove fixing bolts and nuts between strut assembly and steering knuckle with power tool.
- Using a puller (suitable tool), remove drive shaft from steering knuckle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.