Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006FX35 AWD V6-3.5L (VQ35DE)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINETIMING COMPONENTSSYSTEM SPECIFICATIONS
2006 Infiniti FX35 AWD V6-3.5L (VQ35DE)
System Specifications
2006 Infiniti FX35 AWD V6-3.5L (VQ35DE)SECTION System Specifications
Timing Chain Tensioner
Crankshaft Pulley
Tighten crankshaft pulley bolt.
Torque 44.1 Nm (4.5 kg-m, 33 ft. lbs.)
Further tighten crankshaft pulley bolt by 90 degrees. (Angle tightening).
CAUTION: Check the tightening angle by using the angle wrench [SST]. Avoid judgment by visual inspection without SST.
Check tightening angle indicated on the angle wrench indicator plate.
Rotate crankshaft pulley in normal direction (clockwise when viewed from front) to confirm it turns smoothly
For the following operations, perform steps in the reverse order of removal.
Timing Cover
Tighten mounting bolts to the specified torque in numerical order as shown in the figure.
There are two type of mounting bolts. Refer to the following for locating bolts.
M8 bolts: 1, 2 28.4 Nm (2.9 kg-m, 21 ft. lbs.)
M6 bolts: Except the above 12.7 Nm (1.3 kg-m, 9 ft. lbs.)
After all bolts tightened, retighten them to the specified torque in numerical order as shown in the figure.
Image Symbols:
Crankshaft Pulley
Tighten crankshaft pulley bolt.
Torque 44.1 Nm (4.5 kg-m, 33 ft. lbs.)
Further tighten crankshaft pulley bolt by 90 degrees. (Angle tightening).
CAUTION: Check the tightening angle by using the angle wrench [SST]. Avoid judgment by visual inspection without SST.
Check tightening angle indicated on the angle wrench indicator plate.
Rotate crankshaft pulley in normal direction (clockwise when viewed from front) to confirm it turns smoothly
For the following operations, perform steps in the reverse order of removal.
Timing Cover
Tighten mounting bolts to the specified torque in numerical order as shown in the figure.
There are two type of mounting bolts. Refer to the following for locating bolts.
M8 bolts: 1, 2 28.4 Nm (2.9 kg-m, 21 ft. lbs.)
M6 bolts: Except the above 12.7 Nm (1.3 kg-m, 9 ft. lbs.)
After all bolts tightened, retighten them to the specified torque in numerical order as shown in the figure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.