Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006FX35 AWD V6-3.5L (VQ35DE)REPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINECYLINDER BLOCK ASSEMBLYSPECIFICATIONSTIGHTENING TORQUES & SEQUENCESROD BEARING CAP
2006 Infiniti FX35 AWD V6-3.5L (VQ35DE)
Rod Bearing Cap
2006 Infiniti FX35 AWD V6-3.5L (VQ35DE)SECTION Rod Bearing Cap
Rod Bearing Cap
Tighten connecting rod bolt as follows:
Inspect the outer diameter of connecting rod bolt.
Apply engine oil to the threads and seats of connecting rod bolts.
Tighten connecting rod bolts.
Torque 19.6 Nm (2.0 kg-m, 14 ft. lbs.)
Then tighten all connecting rod bolts 90° clockwise (Angle tightening).
CAUTION: Always use the angle wrench [SST: KV10112100 (BT8653A)]. Avoid tightening based on visual check alone.
After tightening connecting rod bolts, make sure that crankshaft rotates smoothly.
CONNECTING ROD BOLT OUTER DIAMETER
^ Measure the outer diameter d at position shown in the figure.
^ If the reduction appears in a position other than d, regard it as d.
Standard 7.90 - 8.00 mm (0.3110 - 0.3150 inch)
Limit 7.75 mm (0.3051 inch)
^ When d exceeds the limit (when it becomes thinner), replace connecting rod bolt with new one.
Tighten connecting rod bolt as follows:
Inspect the outer diameter of connecting rod bolt.
Apply engine oil to the threads and seats of connecting rod bolts.
Tighten connecting rod bolts.
Torque 19.6 Nm (2.0 kg-m, 14 ft. lbs.)
Then tighten all connecting rod bolts 90° clockwise (Angle tightening).
CAUTION: Always use the angle wrench [SST: KV10112100 (BT8653A)]. Avoid tightening based on visual check alone.
After tightening connecting rod bolts, make sure that crankshaft rotates smoothly.
CONNECTING ROD BOLT OUTER DIAMETER
^ Measure the outer diameter d at position shown in the figure.
^ If the reduction appears in a position other than d, regard it as d.
Standard 7.90 - 8.00 mm (0.3110 - 0.3150 inch)
Limit 7.75 mm (0.3051 inch)
^ When d exceeds the limit (when it becomes thinner), replace connecting rod bolt with new one.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.