Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006FX35 AWD V6-3.5L (VQ35DE)REPAIR AND DIAGNOSISCRUISE CONTROLTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESWORK SUPPORT
2006 Infiniti FX35 AWD V6-3.5L (VQ35DE)
Work Support
2006 Infiniti FX35 AWD V6-3.5L (VQ35DE)SECTION Work Support
WORK SUPPORT
Work Item
Cause of Auto-Cancel
1. Touch "WORK SUPPORT" on the "SELECT DIAG MODE" screen. Refer to GI-38, "CONSULT-II Start Procedure". Reading and Clearing Diagnostic Trouble Codes
2. Touch "CAUSE OF AUTO-CANCEL" on the "SELECT WORK ITEM" screen.
3. Cause of automatic cancellation screen will be shown.
CAUTION: Last five cancel (system cancel) causes are displayed.
Display Item List
Laser Beam Adjust
For details, refer to "LASER BEAM AIMING ADJUSTMENT".
Work Item
Cause of Auto-Cancel
1. Touch "WORK SUPPORT" on the "SELECT DIAG MODE" screen. Refer to GI-38, "CONSULT-II Start Procedure". Reading and Clearing Diagnostic Trouble Codes
2. Touch "CAUSE OF AUTO-CANCEL" on the "SELECT WORK ITEM" screen.
3. Cause of automatic cancellation screen will be shown.
CAUTION: Last five cancel (system cancel) causes are displayed.
Display Item List - Work Support:
Display Item List
Laser Beam Adjust
For details, refer to "LASER BEAM AIMING ADJUSTMENT".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.