Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2006FX35 AWD V6-3.5L (VQ35DE)REPAIR AND DIAGNOSISCRUISE CONTROLTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESACTIVE TEST
2006 Infiniti FX35 AWD V6-3.5L (VQ35DE)
Active Test
2006 Infiniti FX35 AWD V6-3.5L (VQ35DE)SECTION Active Test
ACTIVE TEST
CAUTION:
- Never perform the active test while driving.
- Active test cannot be started while ICC system warning indicator illuminates.
1. Touch "ACTIVE TEST" on "SELECT DIAG MODE" screen. Refer to GI-38, "CONSULT-II Start Procedure". Reading and Clearing Diagnostic Trouble Codes
2. Touch any of "ICC BUZZER 1", "METER LAMP", "STOP LAMP" and "BOOSTER SOL/V 3" on selection screen.
3. Touch necessary item and "START".
4. Active test screen will be shown.
ICC BUZZER 1
- Touch "ON" and "OFF" to check that ICC warning chime operates as in the given chart.
METER LAMP
- Start engine.
- Touch "ON" and "OFF" to check that ICC system display operates as in the given chart.
STOP LAMP
- Touch "ON" and "OFF" to check that stop lamp operates as in the given chart.
BOOSTER SOL/V 3
- Start engine.
- Touch any of "MODE 1", "MODE 2", "MODE 3" to check that following operation condition is caused by operating monitor and brake pedal.
- "START" is displayed 10 seconds after operation start. (Active test is completed.)
CAUTION:
- Never perform the active test while driving.
- Active test cannot be started while ICC system warning indicator illuminates.
1. Touch "ACTIVE TEST" on "SELECT DIAG MODE" screen. Refer to GI-38, "CONSULT-II Start Procedure". Reading and Clearing Diagnostic Trouble Codes
2. Touch any of "ICC BUZZER 1", "METER LAMP", "STOP LAMP" and "BOOSTER SOL/V 3" on selection screen.
3. Touch necessary item and "START".
4. Active test screen will be shown.
ICC BUZZER 1
- Touch "ON" and "OFF" to check that ICC warning chime operates as in the given chart.
METER LAMP
- Start engine.
- Touch "ON" and "OFF" to check that ICC system display operates as in the given chart.
STOP LAMP
- Touch "ON" and "OFF" to check that stop lamp operates as in the given chart.
BOOSTER SOL/V 3
- Start engine.
- Touch any of "MODE 1", "MODE 2", "MODE 3" to check that following operation condition is caused by operating monitor and brake pedal.
- "START" is displayed 10 seconds after operation start. (Active test is completed.)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.