1995 Infiniti G20 Automatic, 1RL4F03VFACTORY OEM SERVICE PROCEDURE

Trouble Code Definition

NOTE: When DTC tests indicate to check a component, see indicated component SYSTEM/COMPONENT TESTS article. For Diagnostic Trouble Code (DTC) illustration symbol identification, see Fig 1 . To identify ECM connector terminals, see WIRING DIAGRAMS  section.
DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION CHART

Generic DTC OBD-II DTC System Affected Probable Cause
11  P0340 Camshaft Position No Crank Signal Sensor
12  P0100 Mass Airflow Sensor Circuit Open/Shorted Circuit
13  P0115 Engine Coolant Temperature Sensor Open/Shorted Circuit
14  P0500 Vehicle Speed Sensor (VSS) No VSS Signal
21  P1320 Ignition Signal Circuit Open/Shorted Circuit
25  P0505 Idle Air Control (IACV) Incorrect Idle Speed
31  P0605 ECM Signals Not Normal
32  P0400 EGR Function No EGR Operation
33  P0130 Front HO2S Open/Shorted Circuit/High HO2S Signal
34  P0325 Knock Sensor Open/Shorted Circuit
35  P1401 EGR Temperature Sensor Open/Shorted Circuit
36  P0402 EGRC-BPT Valve Valve Not Operating Correctly
37  P0130 Closed Loop Control System Does Not Enter Closed Loop
41  P0402 Intake Air Temp. Sensor Open/Shorted Circuit
43  P0120 Throttle Position Sensor Open/Shorted Circuit
65  P0304 No. 4 Cyl. Misfire Ignition System
66  P0303 No. 3 Cyl. Misfire Ignition System
67  P0302 No. 2 Cyl. Misfire Ignition System
68  P0301 No. 1 Cyl. Misfire Ignition System
71  P0300 Multiple Cyl. Misfire Ignition System
72  P0420 Catalyst Malfunction Restricted Exhaust
76  P0170 Fuel Injector Malfunction Fuel System Fault
77  P0136 Rear HO2S Open/Shorted Circuit/High HO2S Signal
82  P0335 Crankshaft Pos. Sensor Incorrect Crank Signal
84  P1605 A/T Communication Signal A/T Control Unit Signal Error
91  P0135 Front HO2S Open/Shorted Circuit
95  P1336 Crankshaft Position Sensor Chipped Flywheel Tooth
98  P0125 Engine Coolant Temperature Sensor Faulty Sensor
103  P0705 Park/Neutral Position Switch Open/Shorted Circuit/ Faulty Switch
105  P1400 EGRC Solenoid Open/Shorted Circuit/ Faulty Solenoid
..... P0600  A/T Control Open/Shorted Circuit/Harness or Connectors
Fig 1: Identifying DTC Illustration Symbols (G20)
G90F18734Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.