Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Infiniti G20 Automatic, 1RL4F03VFACTORY OEM SERVICE PROCEDURE
Engine Controls - Tests W/Codes 2.0L
- Introduction
- Self-Diagnostic System
- Final Check
- Trouble Code Definition
- Diagnostic Trouble Code (DTC) Testing
- Notes
- ECM Harness Connector
- DTC 11: Crankshaft Position (CKP) Sensor
- DTC 12: Mass Airflow (MAF) Sensor
- DTC 13: Engine Coolant Temperature (ECT) Sensor
- DTC 14: Vehicle Speed Sensor (VSS)
- DTC 21: Ignition Signal
- DTC 25: Idle Air Control (IAC)
- DTC 31: ECM
- DTC 32: EGR Function
- DTC 33: Front Heated Oxygen Sensor (Ho2S)
- DTC 34: Knock Sensor (KS)
- DTC 35: EGR Temperature Sensor
- DTC 36: EGR Control BACKPRESSURE Transducer (EGRC-BPT) Valve
- DTC 37: Closed Loop Control
- DTC 41: Intake Air Temperature (IAT) Sensor
- DTC 43: Throttle Position Sensor (TPS)
- DTC 65, 66, 67, 68, Or 71: CYL Misfire/Multiple CYL Misfire
- DTC 72: 3-Way Catalyst Function
- DTC 76: Fuel Injection System
- DTC 77: Rear Heated Oxygen Sensor (Ho2S)
- DTC 82: Crankshaft Position (CKP) Sensor
- DTC 84: Automatic Transmission (A/T) Control
- DTC 91: Front Heated Oxygen Sensor (Ho2S)
- DTC 95: Crankshaft Position (CKP) Sensor
- DTC 98: Engine Coolant Temperature (ECT) Sensor
- DTC 103: Inhibitor/Neutral Position Switch
- DTC 105: EGR & Canister Control Valve
- DTC P0600: A/T Control
- Summary
- Wiring Diagrams
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
