Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI1992M30 2D CONVERTIBLEREPAIR AND DIAGNOSISGENERAL INFORMATIONRESTRAINTSAIR BAG DEACTIVATION PROCEDURESPORSCHESERVICE PRECAUTIONS
1992 Infiniti M30 2D Convertible
Service Precautions
1992 Infiniti M30 2D ConvertibleSECTION Service Precautions
Observe these precautions when working with air bag systems:
- Disable air bag system before servicing any air bag or steering column component. See DISABLING & ACTIVATING AIR BAG SYSTEM .
- Wait 20 minutes after disabling air bag system before servicing. Air bag system voltage is maintained for about 20 minutes after system is disabled. Failure to wait 20 minutes before servicing system may cause accidental air bag deployment and possible personal injury.
- Because of critical operating requirements of system, DO NOT service any air bag component. Repair is made by replacement only.
- DO NOT allow grease, oil, cleaning solutions or similar substances to contact air bag units.
- DO NOT subject air bag units to temperatures warmer than 195°F (90°C).
- Replace air bag units, impact sensors and control units which have fallen from a height of 1.5 feet or more.
- DO NOT install additional trim, labels or stickers on steering wheel or in area of passenger-side air bag.
- DO NOT repair or modify air bag system wiring.
- Air bag system must be disabled before electric welding can be performed on vehicle.
- DO NOT route wires from other electrical equipment in vicinity of air bag wire harness.
- Wash hands thoroughly after handling deployed air bags.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.