SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI1992M30 2D CONVERTIBLEREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONRESTRAINTSAIR BAG DEACTIVATION PROCEDURESVOLVODISABLING & ACTIVATING AIR BAG SYSTEM
1992 Infiniti M30 2D Convertible

Disabling & Activating Air Bag System

1992 Infiniti M30 2D ConvertibleSECTION Disabling & Activating Air Bag System
WARNING: NEVER disconnect crash sensor connector or standby power unit to disable SRS system.
  1. Before proceeding, follow air bag service precautions. See SERVICE PRECAUTIONS . Before performing any repairs, disconnect and shield negative battery cable.
  2. Locate and disconnect Orange and Yellow SRS connectors on driver's side of center console, under carpet. See Fig 1. DO NOT disconnect harness connection at crash sensor or air bag will deploy.
  3. After repairs, ensure all wiring and component connectors are reconnected. To activate air bag system, reconnect Orange and Yellow SRS connectors on drivers side of center console, under carpet. Reconnect negative battery cable. Check SRS warning light to ensure system is functioning properly. See SYSTEM OPERATION CHECK .
    Fig 1: Locating SRS Disabling Connectors
    G92G21341Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.