Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Mirror Switch Test
With ignition switch in ON or ACC position, check continuity between specified terminals. See POWER MIRROR SWITCH CONTINUITY TEST table. For terminal numbers and wire colors, See Fig 1 , Fig 2 or Fig 3 . Before performing following tests, ensure circuit ground, circuit harness wiring and circuit fuse are okay. Check that all circuit connections are clean and tight.
| Application | Terminals | |
|---|---|---|
| Left Mirror | ||
| Off & Neutral | N/A | |
| Right | 1 & 2; 3 & 6 | |
| Left | 1 & 6; 2 & 3 | |
| Up | 1 & 7; 2 & 3 | |
| Down | 1 & 2; 3 & 7 | |
| Right Mirror | ||
| Off & Neutral | N/A | |
| Right | 1 & 2; 3 & 4 | |
| Left | 1 & 4; 2 & 3 | |
| Up | 1 & 5; 2 & 3 | |
| Down | 1 & 2; 3 & 5 | |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.