SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI1992M30 2D CONVERTIBLEREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSTESTINGACCEL SWITCH CIRCUIT TEST
1992 Infiniti M30 2D Convertible

ACCEL Switch Circuit Test

1992 Infiniti M30 2D ConvertibleSECTION ACCEL Switch Circuit Test
  1. Turn ignition off. Press and hold RESUME/ACCEL switch. Check voltage between cruise control module connector terminals No. 1 and 3. See Figure or Figure . If voltage is present, go to next step. If voltage is not present, go to step 3).
  2. Check voltage between terminals No. 1 and 3 after releasing RESUME/ACCEL switch. If voltage is present, go to step 3). If voltage is not present, test drive vehicle. If vehicle does not accelerate when RESUME/ACCEL switch is pressed, replace cruise control module. If vehicle does not maintain faster speed when RESUME/ACCEL switch is pressed, replace cruise control module.
  3. Press and hold RESUME/ACCEL switch. Using an ohmmeter, check for continuity between terminals No. 1 and 3 at RESUME/ACCEL switch. If continuity does not exist, replace RESUME/ACCEL switch. If continuity exists, check RESUME/ACCEL wiring circuit.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.