Repair Procedures: Removal

2024 Hyundai Palisade Limited, FWDSECTION Removal
WARNING:
  • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift. (Refer to General Information - "LIFT AND SUPPORT POINTS ")
  1. Disconnect the battery (-) terminal.
  2. Left the vehicle.
  3. Disconnect the canister close valve connector (A).
    G15477182Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the vent hose quick-connector (A), the vapor hose quick-connector (B) from the canister.
    G15477183Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the canister assembly (A) after loosening the mounting bolt and nut.
    G15477184Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the mounting bolt (A) and then separate the fuel tank air filter (B) from the canister after rotating it in the direction of the arrow in the figure.
    G15477185Courtesy of HYUNDAI MOTOR AMERICA
    G15477186Courtesy of HYUNDAI MOTOR AMERICA
    G15477187Courtesy of HYUNDAI MOTOR AMERICA
  7. Release the lever (A) and then separate the canister close valve (B) from the fuel tank air filter by rotating the valve in the direction of the arrow in the image below.
    G15477188Courtesy of HYUNDAI MOTOR AMERICA
    G15477189Courtesy of HYUNDAI MOTOR AMERICA
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.