(Transmission Control Module (TCM) Removal And Installation)

2024 Hyundai Kona Limited, 4WDSECTION (Transmission Control Module (TCM) Removal And Installation)
ABBREVIATED PROCEDURE

Work H/W Tightening torque N.m (kgf.m/lb-ft) SST/Equipment Chemical etc
  • Removal 
1 Perform the oil pressure characteristics backup procedure using the diagnostic tool when replacing with a new TCM - - Diagnostic tool - Refer to appropriate service information
2 Disconnect the negative (-) battery cable - - - - -
3 Disconnect the TCM connectors - - - - -
4 Remove the TCM bracket assembly after removing the bolts and nut Bolt Nut 9.8 - 11.8 (1.0 - 1.2/7.2 - 8.7) - - -
5 Remove the TCM from the bracket after removing the bolts Bolt 9.8 - 11.8 (1.0 - 1.2/7.2 - 8.7) - - -
  • Installation 
Install in the reverse order of removal Refer to appropriate service information
  • Additional work 
  • Perform the oil pressure characteristics input procedure using the diagnostic tool when replacing with a new TCM
  • In order to avoid any problem including sense of starting delay of the transmission and shock at acceleration and vehicle start, make sure to process learning for TCM after replacing the TCM
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.