Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2024KONA LIMITED, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 27 (ENGINE CONTROL SYSTEM DIAGNOSIS - 2.0 (10 OF 15))DTC P0630-00: VIN NOT PROGRAMMED OR INCOMPATIBLE-ECM/PCMDTC INFORMATIONDTC SETTING CONDITION
2024 Hyundai Kona Limited, 4WD
DTC Setting Condition
2024 Hyundai Kona Limited, 4WDSECTION DTC Setting Condition
WARNING: This page is about a different variant/trim than selected.
| Item | DTC setting condition |
|---|---|
| Main Action | Monitoring whether vehicle identification number is entered |
| Prerequisite Condition | - |
| Trouble Determination | RAM error Discrepancy between actual checksum value and memorized checksum value Version mismatch between PCM software or calibration |
| Diagnosis Time | 1 second |
| Threshold Value for Warning Light | 1st drive cycle |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.