Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Alternator Replacement
Information
- If there is no problem in the alternator circuit, it is possible to suspect that the alternator is defective.
In this case, check if the fault code has been cleared by replacing the alternator separately.
- If the malfunction continues even after replacing the alternator, do not replace it as it is not the cause of the malfunction.
- To determine the failure of the existing alternator, replace it with a non-defective alternator. (Refer to ALTERNATOR REMOVAL AND INSTALLATION )
- Check that the fault code does not recur and that it operates normally.
OK
Since the system is operating normally, it is determined that the alternator is defective,
Go to "Final DTC checking" procedure.
NG
The alternator cannot be determined as the cause of failure.
If the fault code reoccurs, reinstall the original alternator and Go to "Final DTC Checking" inspection for PCM procedure in the item.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.