Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Roll Rod Bracket
2024 Hyundai Kona Limited, 4WDSECTION Roll Rod Bracket
ABBREVIATED PROCEDURE
| Work | H/W | Tightening torque N.m (kgf.m/lb-ft) | SST/Equipment | Chemical | etc | |
|---|---|---|---|---|---|---|
|
||||||
| 1 | Remove the engine room under cover (Refer to Engine and transaxle Assembly - "ENGINE ROOM UNDER COVER ") |
- | - | - | - | - |
| 2 | Remove the roll rod bracket after removing the bolts | Bolt (B) | 107.9 - 127.5 (11.0 - 13.0/79.6 - 94.0) | - | - | Refer to appropriate service information |
| Nut (B) | ||||||
| Bolt (C) | 49.0 - 63.7 (5.0 - 6.5/36.2 - 47.0) | |||||
| 3 | Remove the roll rod mounting support bracket after removing the bolts | Bolt | 49.0 - 68.6 (5.0 - 7.0/36.2 - 50.6) | - | - | - |
|
||||||
| Install in the reverse order of removal | - | |||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.