Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2024IONIQ 5 SE, AWDREPAIR AND DIAGNOSISSUSPENSIONWHEEL ALIGNMENTTIRES/WHEELS/ALIGNMENTALIGNMENTINSPECTIONFRONT WHEEL ALIGNMENTTOETOE ADJUSTMENT
2024 Hyundai Ioniq 5 SE, AWD
Toe adjustment
2024 Hyundai Ioniq 5 SE, AWDSECTION Toe adjustment
- Loosen the tie rod end lock nut.
- Remove the bellows clip to prevent the bellows from being twisted.
- Adjust the toe by screwing or unscrewing the tie rod. Toe adjustment should be made by turning the right and left tie rods by the same amount.
Toe
Total: 0.1° ± 0.2°
Individual: 0.05° ± 0.1°
Tie rod Direction of rotation Toe Left side Rotates backward Decrease (Toe in) (Driver side) Rotates forward Increase (Toe out) Right side Rotates backward Increase (Toe out) (Passenger side) Rotates forward Decrease (Toe in) - When completing the toe adjustment, install the bellows clip and tighten the tie rod end lock nut to specified torque.
Tightening torque:
49.0 - 53.9 N.m (5.0 - 5.5 kgf.m, 36.2 - 39.8 lb.ft)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.