Buzzer Operation Is Defined In The Following Chart

2022 Hyundai Tucson XRT, 4WDSECTION Buzzer Operation Is Defined In The Following Chart
Β  BUZZER LAMP (1) Remark
T/gate start 2 times 2 times When T/gate is triggered by Remote Control or T/gate Console Switch
T/gate start n.a. n.a. When T/gate is triggered by T/gate Inner Switch or T/gate Outer Handle Switch
T/gate stop n.a. n.a. Β 
System error 3 Times - PCU/Tailgate antiplay active, Over-/under voltage condition, End position-/position error, spindle error, CAN error, Latch closed when Tailgate open
T/gate not closed 10 times 10 times Latch Lock Switch not present
During Calibration run Continuous ON-OFF beeping n.a. Activate buzzer but not C_PT Hazard
Max. End Position learned n.a. 2 times Buzzer confirms learning finished
Max. End Position deleted 1 time n.a. Buzzer confirms "position deleted"
Car is moving with open T/gate 10 times n.a. T/gate open AND Speed >3 km/h
Garage Position saved 2 times n.a. Buzzer confirms "New Garage Position"
(1) Lamp will be synchronized by sending C_PTHazard simultaneously to Buzzer signal
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.