Quick Lookups: Fluids

2022 Hyundai Santa Cruz SEL, FWDSECTION Fluids
FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil 3.50 OZS. 0.1 L PAG Approximate capacity. S
Air Cond Refrigerant 1.30 LBS. 0.58 KG R-1234yf Approximate capacity. S
Automatic Transmission Fluid Automatic Trans 6.87 QTS. 6.5 L MICHANG ATF SP-IV SK ATF SP-IV, NOCA AFT SP-IV, HYUNDAI genuine ATF SP-IV or other brands meeting the specifications approved by Hyundai Motor Co., Approximate capacity. S
Brake Fluid N/A N/A SAE J1704 DOT-4 LV, FMVSS 116 DOT-4, ISO4925 CLASS-6 As required. S
Differential Gear Oil Rear 0.61 QTS. 0.57 L Hypoid Gear Oil API - GL-5, SAE 75W-85 (SK HCT-5 Gear Oil 75W-85 or equivalent) Approximate capacity. S
Engine Coolant Normally Aspirated 10.00 QTS. 9.46 L Mixture of antifreeze and water (Phosphate-based Ethylene glycol coolant for aluminum radiator) Approximate capacity. S
Engine Oil Normally Aspirated 6.13 QTS. 5.8 L SAE 0W-20, API - SN PLUS/SP or ILSAC GF-6 Full Synthetic grade engine oil Requires: API SN PLUS (or above) Full synthetic grade engine oil. If a lower grade engine oil (mineral oil including Semi-synthetic) is used, then the engine oil and engine oil filter must be replaced. S
Fuel Tank 17.69 GALS. 66.96 L S
Transfer Case Fluid Normally Aspirated 0.68 QTS. 0.64 L Hypoid Gear Oil API - GL-5, SAE 75W-85 SK HCT-5 Gear Oil SAE 75W-85 or equivalent Approximate capacity. S
Windshield Washer Fluid N/A N/A Use a good quality windshield washer fluid, diluted with water as necessary. S
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.