SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2017SANTA FE SE, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 6 (4WD CONTROL SYSTEM)4WD CONTROL SYSTEMREPAIR PROCEDURESADJUSTMENTDESCRIPTIONCOMPENSATION REQUIREMENT AND PROCEDURE
2017 Hyundai Santa Fe SE, FWD

Compensation Requirement and Procedure

2017 Hyundai Santa Fe SE, FWDSECTION Compensation Requirement and Procedure
WARNING: This page is about a different variant/trim than selected.
  1. Simultaneous replacement of 4WD ECU (Controller) and coupling
    • Does not require compensation.
  2. Replacement of coupling only
    • Reset the 4WD ECU's (Controller) clutch learning.
    G12034420Courtesy of HYUNDAI MOTOR AMERICA
    G12034421Courtesy of HYUNDAI MOTOR AMERICA
  3. Replacement of 4WD ECU (Controller) only
    • Before replacement: Check the ECU's clutch learning.
      G12034422Courtesy of HYUNDAI MOTOR AMERICA
      G12034423Courtesy of HYUNDAI MOTOR AMERICA
    • After replacement: Enter the original ECU's clutch learning into the replacement ECU.
      G12034424Courtesy of HYUNDAI MOTOR AMERICA
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.