SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2017SANTA FE SE, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (2 OF 3)DTC P0453: EVAPORATIVE EMISSION SYSTEM-PRESSURE SENSOR HIGH INPUTCOMPONENT INSPECTIONCHECK FTPS
2017 Hyundai Santa Fe SE, FWD

Check FTPS

2017 Hyundai Santa Fe SE, FWDSECTION Check FTPS
  1. IG "OFF" and connect GDS to DLC (Data Link Connector).
  2. Monitor "FTPS" parameter on service data.

    Specification: 

    OUTPUT VOLTAGE PRESSURE SPECIFICATIONS

    Pressure (kPa) Output Voltage (V)
    -6.67 (26.7VAC) 0.5
    0 2.5
    6.67 (-26.7VAC) 4.5
  3. Is the "FTPS" parameter on the service data O.K?

    YES 

    • Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Substitute with a known - good FTPS and check for proper operation. If the problem is corrected, replace FTPS and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.