SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2017SANTA FE SE, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (2 OF 3)DTC P0315: CRANKSHAFT POSITION SYSTEM VARIATION NOT LEARNEDDTC INFORMATIONDTC DETECTING CONDITION
2017 Hyundai Santa Fe SE, FWD

DTC Information: DTC Detecting Condition

2017 Hyundai Santa Fe SE, FWDSECTION DTC Detecting Condition
DTC DETECTING CONDITIONS AND POSSIBLE CAUSES

Item Detecting Condition Possible Cause
DTC Strategy
  • This DTC indicates that a crank shaft reluctor tooth error has not been learned.
  1. Poor connections CKPS
  2. Condition of the target wheel
  3. PCM
Enable Conditions
  • Engine load between 10% and 90%
  • Engine speed between 2000 rpm and 4000 rpm
  • TEC (Tooth Error Correction) RPM stability timer longer than 10sec
  • Coolant temperature between 0°C (32°F) and 110°C (230°F)
  • Not active disabling faults
Threshold value
  • Distance driven without learning (during fuel cut off) tooth error longer than 4000 km (2485 miles)
  • Actual Value is higher or lower than calibrated value
Diagnosis Time
  • -
MIL On Condition
  • NO MIL ON (DTC only)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.