Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Check Fuel Pressure
2017 Hyundai Santa Fe SE, FWDSECTION Check Fuel Pressure
NOTE:
- Be cautious fuel is explosive and an empty fuel tank can still contain explosive gases. When working on fuel systems make sure to supply adequate ventilation to the work area. Do not smoke, and keep sparks and open flames away.
- The fuel system remains under pressure when the engine is not running. Release fuel system pressure before disconnecting any fuel line to reduce the chance of personal injury or fire damage to vehicle components.
- IG "OFF". Disconnect Fuel Pump Relay in Junction Box.
- Start engine and wait until it stalls.
- IG "OFF". Connect Fuel Pump Relay.
- Install the fuel pressure gauge to the delivery pipe with the fuel pressure gauge adaptor. (Refer to REPAIR PROCEDURES .)
- Activate the fuel pump, check that there are no fuel leaks from the pressure gauge or fuel system.
- Measure the fuel pressure at idle.
Specification: 400 ~ 600 kPa (4.07 ~ 6.12 kg/cm2 , 58 ~ 87 psi)
- Is the measured fuel pressure within specifications?
YES
- Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Repair or replace according to the table below. Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
CONDITIONS AND POSSIBLE CAUSESCondition Possible Cause Fuel Pressure is too low Fuel filter, fuel pressure regulator, in-tank fuel hose or the fuel pump Fuel Pressure is too high Fuel pressure regulator, hose or pipe
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.