DTC Information: DTC Detecting Condition

2017 Hyundai Santa Fe SE, FWDSECTION DTC Detecting Condition
DTC DETECTING CONDITIONS AND POSSIBLE CAUSES

Item Detecting Condition Possible cause
DTC Strategy
  • Signal high
  1. Poor Connection
  2. Short to battery in signal harness
  3. Open in ground harness
  4. TPS
  5. PCM
Enable Conditions
  • IG "ON"
Threshold value
  • The voltage of TPS greater than 4.75V
Diagnosis Time
  • Continuous (more than 0.1 sec. failure for every 8.5 sec. test)
MIL On Condition
  • 1 Driving Cycle
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.