Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Check OTS Resistance
2017 Hyundai Santa Fe SE, FWDSECTION Check OTS Resistance
- IG "OFF". Disconnect OTS connector.
- Measure resistance between signal and ground terminals of OTS connector (Component Side) after recording the temperature of EOTS with GDS.
Specification:
OTS CONNECTOR RESISTANCE SPECIFICATIONTemperature (°C/°F) Resistance (kΩ) -40°C (-40°F) 52.15kΩ -20°C (-4°F) 16.52kΩ 0°C (32°F) 6.0kΩ 20°C (68°F) 2.45kΩ 40°C (104°F) 1.11kΩ 60°C (140°F) 0.54kΩ 80°C (176°F) 0.29kΩ - Is the measured resistance within specification?
YES
- Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known - good OTS and check for proper operation. If the problem is corrected, replace OTS and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.