Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSHYUNDAI2017SANTA FE SE, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERYFUEL DELIVERY SYSTEMFUEL PUMPREPAIR PROCEDURESINSPECTIONFUEL SENDER
2017 Hyundai Santa Fe SE, FWD
Fuel sender
2017 Hyundai Santa Fe SE, FWDSECTION Fuel sender
- Turn the ignition switch OFF, and then remove battery (-) cable.
- Remove the fuel pump assembly.
- Using an ohmmeter, measure the resistance between terminals 2 and 3 of sender connector (A) at each float level.FUEL SENDER PIN DESCRIPTION CHART
Pin No Description 1 - 2 Fuel sender signal 3 Fuel sender ground 4 Fuel pump motor (+) 5 Fuel pump motor ground - Also check that the resistance changes smoothly when the float is moved from "E" to "F".FUEL SENDER RESISTANCE SPECIFICATIONS
Position Resistance (Ξ©) E 197 ~ 203 Warning lamp 168 ~ 172 1/2 64.2 ~ 68.2 Sender (F) 6 ~ 10
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.