SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2017SANTA FE SE, FWDREPAIR AND DIAGNOSISELECTRICALMOTORS, SWITCHES, RELAYSBODY CONTROL MODULE (BCM) DIAGNOSISDTC B1605-00: CAN TIMEOUT BETWEEN IPM AND DDMDTC INFORMATIONDTC DETECTING CONDITION
2017 Hyundai Santa Fe SE, FWD

DTC Information: DTC Detecting Condition

2017 Hyundai Santa Fe SE, FWDSECTION DTC Detecting Condition
DTC DETECTING CONDITIONS AND POSSIBLE CAUSES

Item Detecting Condition Possible Cause
DTC Strategy
  • CAN Comm. Check (BCM ↔ DDM)
  • IG ON
    1. No receiving CAN Data owing to BUS OFF (Check CAN BUS ERROR DTC is being.)
    2. DDM CAN High/Low Lines open together
    3. Check DDM (Including the related fuses)
    4. DDM CAN High/Low Lines open
Enable Conditions
  • BCM power on
Threshold Value
  • No message from DDM to BCM for 10 sec.
Diagnostic Time
  • 10 sec
DTC Erasing Time
  • DTC is erased immediately after receiving data from DDM.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.