DTC Information: DTC Detecting Condition

2017 Hyundai Santa Fe SE, FWDSECTION DTC Detecting Condition
DTC DETECTING CONDITIONS AND POSSIBLE CAUSES

Item Detecting Condition Possible Cause
DTC Strategy
  • Signal output of Rear Center Left Sensor and LIN line checking
  1. TX line of Rear Center Left Sensor open or poor connection.
  2. Ground line of Rear Center Left Sensor open or poor connection.
  3. Power line of Rear Center Left Sensor open or poor connection.
  4. Replace a sensor after checking a wire of Rear Center Left Sensor.
Enable Conditions
  • IG KEY ON, Shift lever R
Threshold Value
  • Rear Center Left Sensor fault
  • LIN communication fault
  • Poor connection
  • LIN line open
Diagnostic Time
  • Immediately (More than 4 times after IG KEY ON)
DTC Erasing Time
  • DTC is erased immediately after trouble fixed
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.