Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSHYUNDAI2017SANTA FE SE, FWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLELECTRONIC STABILITY CONTROL (ESC) SYSTEMTROUBLESHOOTINGEVEN AFTER THE ENGINE IS STARTED, THE ABS WARNING LAMP REMAINS ONINSPECTION PROCEDURESCHECK THE CAN CIRCUIT RESISTANCE FOR ABS WARNING LAMP
2017 Hyundai Santa Fe SE, FWD
Check The CAN Circuit Resistance For ABS Warning Lamp
2017 Hyundai Santa Fe SE, FWDSECTION Check The CAN Circuit Resistance For ABS Warning Lamp
- Disconnect the instrument cluster connector (M08) and turn the ignition switch OFF.
- Measure the resistance between terminal (M08) 32 and 33 of the cluster harness side connector.
Specification:Β 60Ξ©
- Is resistance within specification?
YESΒ
- Repair ABS warning lamp bulb or instrument cluster assembly.
NOΒ
- Check the CAN circuit wiring for ABS warning lamp below.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.