Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2017SANTA FE SE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXSMART JUNCTION BLOCK DTCS
2017 Hyundai Santa Fe SE, FWD
Smart Junction Block DTCS
2017 Hyundai Santa Fe SE, FWDSECTION Smart Junction Block DTCS
SMART JUNCTION BLOCK DIAGNOSTIC TROUBLE CODE IDENTIFICATION
| DTC | Description |
|---|---|
| DTC B1602 | 00: CAN Line Error (B-CAN) |
| DTC B1603 | 00: CAN Bus OFF (B-CAN) |
| DTC B2510 | 00: Head Lamp High RH SCG |
| DTC B2511 | 00: Head Lamp High LH SCG |
| DTC B2512 | 00: Head Lamp Low RH SCG |
| DTC B2513 | 00: Head Lamp Low LH SCG |
| DTC B2514 | 00: External Tail Lamp RH Circuit Short to Ground |
| DTC B2515 | 00: External Tail Lamp LH Circuit Short to Ground |
| DTC B2516 | 00: Front Fog Lamp Circuit Short to Ground |
| DTC B2517 | 00: Internal Tail Lamp Circuit Short to Ground |
| DTC B2518 | 00: Turn Signal LH Front Open Circuit |
| DTC B2519 | 00: Turn Signal LH Rear Open Circuit |
| DTC B2520 | 00: Turn Signal RH Front Open Circuit |
| DTC B2521 | 00: Turn Signal RH Rear Open Circuit |
| DTC B2522 | 00: Turn Signal LH Front SCG |
| DTC B2523 | 00: Turn Signal LH Rear SCG |
| DTC B2524 | 00: Turn Signal RH Front SCG |
| DTC B2525 | 00: Turn Signal RH Rear SCG |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.