SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2017SANTA FE SE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESANTILOCK BRAKE SYSTEM (ABS)/ELECTRONIC STABILITY CONTROL (ESC) DIAGNOSISDTC C1210: WHEEL SPEED SENSOR REAR-RH RANGE/PERFORMANCE/INTERMITTENTDTC INFORMATIONDTC DETECTING CONDITION
2017 Hyundai Santa Fe SE, FWD

DTC Information: DTC Detecting Condition

2017 Hyundai Santa Fe SE, FWDSECTION DTC Detecting Condition
DTC DETECTING CONDITIONS AND POSSIBLE CAUSES

Item Detecting Condition Possible cause
DTC Strategy
  • Signal monitoring
  1. Improper installation of wheel speed sensor
  2. Abnormal Rotor and wheel bearing
  3. Faulty Wheel speed sensor
Enable Conditions Case 1 (Speed jump)
  • Controller counts the number of the wheel acceleration of 100g [(25km/h) for 7ms]. When the numbers at one wheel exceed 56 times, or When the numbers at more two wheels exceed 5 times, controller recognize the failure
  • Controller counts the number of the wheel acceleration of 70g [(17.5km/h) for 7ms]. When the numbers at one wheel exceed 126 times, or When the numbers at more two wheels exceed 20 times, controller recognize the failure
  • Controller counts the number of the wheel deceleration of - 100g [(-25km/h) for 7ms]. When the numbers at each wheel exceed 56 times, controller recognize the failure
  • The wheel deceleration of -100g [(-25km/h) for 7ms] causes the controller to start monitoring this failure and to compare the wheel velocity with the vehicle velocity from next cycle. When its difference of -100g is continued for more than 140msec, controller recognize the failure
  • In case that any sensor failure at other wheel was already detected, When the numbers of 100g at each wheel exceed 5 times, or When the numbers of 70g at each wheel exceed 20 times, controller recognize the failure
    • The counter of speed jump is cleared every 30min.
    • This monitoring is performed for the period that the velocity of each wheel exceeds 2km/h.
Case 2 (wrong exciter)
  • Max. wheel velocity exceeds 20km/h and the wheel velocity is 40% of max. wheel velocity. If this condition is lasted for 2 minutes
  • Max. wheel velocity exceeds 40km/h and the wheel velocity is 60% of max. wheel velocity. If this condition is lasted for 2 minutes
Fail Safe
  1. Only one wheel failure: Inhibit the ABS/ESC (ESP) control, allow the EBD control. The ABS/ESC (ESP) warning lamps are activated, the EBD warning lamp is not activated
  2. More than two wheels failure: The ABS/EBD/ESC (ESP) functions are inhibited. The ABS/EBD/ESC (ESP) warning lamps are activated
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.