Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHYUNDAI2017SANTA FE SE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEMROOM LAMPREPAIR PROCEDURESREMOVAL

2017 Hyundai Santa Fe SE, FWD

Repair Procedures: Removal

2017 Hyundai Santa Fe SE, FWDSECTION Removal

Disconnect the negative (-) battery terminal.
Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver.

Courtesy of HYUNDAI MOTOR AMERICA
Replace the room lamp bulb (A).

Courtesy of HYUNDAI MOTOR AMERICA
Separate the room lamp (A) from the roof trim after loosening the screws (2EA).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the room lamp (B) after disconnecting the connector (A).

Courtesy of HYUNDAI MOTOR AMERICA

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.