SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2017SANTA FE SE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASBLIND SPOT DETECTION DIAGNOSIS - RIGHTDTC C1812-87: CAN TIME-OUT GATEWAYDTC INFORMATIONDTC DETECTING CONDITION
2017 Hyundai Santa Fe SE, FWD

DTC Information: DTC Detecting Condition

2017 Hyundai Santa Fe SE, FWDSECTION DTC Detecting Condition
DTC DETECTING CONDITIONS AND POSSIBLE CAUSES

Item Detecting Condition Possible cause
DTC Strategy
  • CAN communication check between BSD ECU and IPM
  1. Open or short in CAN communication line
  2. IPM (GWAY included)
Enable Condition
  • IG ON (BSD Switch ON)
  • ENG "ON"
Threshold Value
  • If GWAY CAN message is not received
Detecting Time
  • 500ms (0.5 second)
Fail Safe
  • Rear and side alarm control
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.