Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2017SANTA FE SE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASBLIND SPOT DETECTION DIAGNOSIS - RIGHTDTC C120B-15: LED RIGHT CIRCUIT SHORT TO BATTERY OR OPENVERIFICATION OF REPAIRVERIFICATION OF VEHICLE REPAIR
2017 Hyundai Santa Fe SE, FWD
Verification Of Vehicle Repair
2017 Hyundai Santa Fe SE, FWDSECTION Verification Of Vehicle Repair
After a repair, it is essential to verifying that the fault has been corrected.
- Turn IG On again.
- Ture BSD Off and On there times. (When you turn BSD on, maintain on state for about 3s.)
- Connect GDS and select "Diagnostic Trouble Codes (DTC) " mode.
- Using a GDS, Clear DTC.
- Operate the vehicle within DTC Enable conditions in General Information.
- Are any DTCs present?
YES
- Go to the applicable troubleshooting procedure.
NO
- System is performing to specification at this time.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.