Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Neutralization Status Check
2017 Hyundai Santa Fe SE, FWDSECTION Neutralization Status Check
- Connect the cable of GDS to the data link connector in driver side crash pad lower panel.
- After IG ON, select the "Neutralization mode".
INPUT SWITCH LIST
| No | Item name | Unit |
|---|---|---|
| 1 | SSB SW1 | - |
| 2 | SSB SW2 | - |
| 3 | ACC | - |
| 4 | IGN1 | - |
| 5 | IGN2 | - |
| 6 | ACC/IGN1/IGN2 Relay | - |
| 7 | Gear "P" Position (A/T) Clutch SW (M/T) | - |
| 8 | Brake SW | - |
| 9 | FL Door Lock Button | - |
| 10 | FR Door Lock Button | - |
| 11 | Liftgate Release Button | - |
| 12 | Battery Voltage | - |
| 13 | Wheel Speed | - |
ACTUATOR LIST
| No. | Item name | Condition |
|---|---|---|
| 1 | External Buzzer | Ignition switch ON Engine off |
| 2 | Interior Antenna 1 Active | Ignition switch ON Engine off |
| 3 | Interior Antenna 2 Active | Ignition switch ON Engine off |
| 4 | Interior Antenna 3 Active | Ignition switch ON Engine off |
| 5 | Bumper/trunk Antenna Active | Ignition switch ON Engine off |
| 6 | DRV_DR Antenna Active | Ignition switch ON Engine off |
| 7 | AST_DR Antenna Active | Ignition switch ON Engine off |
| 8 | BBS Illumination (OFF/ACC/ON) | Ignition switch ON Engine off |
| 9 | ACC/IGN1/IGN2 Relay | Ignition switch ON Engine off |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.