Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014VELOSTER RE:FLEXREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEREAR PARKING ASSIST SYSTEMPARKING ASSIST SENSORREPAIR PROCEDURESREMOVAL
2014 Hyundai Veloster RE:FLEX
Repair Procedures: Removal
2014 Hyundai Veloster RE:FLEXSECTION Removal
- Remove the rear bumper.
(Refer to "REAR BUMPER ")
- Disconnect the connector from the rear bumper.
- Disconnect the connector (B) from the rear ultra sensor (A).
- Pull out the sensor (A) by opening the sensor holder (C) out.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.