Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014VELOSTER BASE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM DIAGNOSIS (2 OF 2) - NON-TURBODTC P0564: CRUISE CONTROL MULTI-FUNCTION INPUT A CIRCUITCOMPONENT INSPECTION
2014 Hyundai Veloster Base, Standard Trans
Component Inspection
2014 Hyundai Veloster Base, Standard TransSECTION Component Inspection
- Check auto cruise switch
- IG "OFF" and disconnect Cruise switch connector.
- Measure resistance between signal and power terminals of Cruise switch connector with each switch depressed. (Component side)
- Measure resistance between signal and ground terminals of Cruise remocon connector with each switch depressed. (Component side)PART RESISTANCE SPECIFICATION
Item Resistance (Ω) ON/OFF switch 3.9 kΩ ± 5% SET switch 220 Ω ± 5% RESUME switch 910 Ω ± 5% CANCEL switch 0 Ω ± 5% - Is the measured resistance within specification?
YES
- Substitute with a known - good ECM and check for proper operation. If the problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known - good auto cruise switch and check for proper operation. If the problem is corrected, replace auto cruise switch and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.