Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014VELOSTER BASE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESUN ROOF/T-TOP/CONVERTIBLE TOPEXTERIOR BODY PANELSBODY SIDE MOLDINGSREPAIR PROCEDURESREPLACEMENTFRONT WHEEL GUARD REPLACEMENT
2014 Hyundai Veloster Base, Standard Trans
Front Wheel Guard Replacement
2014 Hyundai Veloster Base, Standard TransSECTION Front Wheel Guard Replacement
CAUTION:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.
- Remove the front tire.
- After loosening the mounting clips and screws, then remove the front wheel guard (A).
[LH]
[RH]
- Installation is the reverse of removal.NOTE:
- Replace any damaged clips.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.