Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014SONATA HYBRID BASEREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSGENERAL INFORMATION (FUEL SYSTEM) (HEV)SPECIFICATIONSACTUATORS
2014 Hyundai Sonata Hybrid Base
General Information (Fuel System) (HEV): Specifications: Actuators
2014 Hyundai Sonata Hybrid BaseSECTION Actuators
Injector
- Specification
ACTUATORS SPECIFICATIONS CHART
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 13.8 ~ 15.2 [20°C (68°F)] |
ETC Motor [integrated into ETC Module]
- Specification
ETC MOTOR SPECIFICATIONS CHART
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 1.2 ~ 1.8 [20°C (68°F)] |
Purge Control Solenoid Valve (PCSV)
- Specification
PURGE CONTROL SOLENOID VALVE SPECIFICATIONS CHART
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 19.0 ~ 22.0 [20°C (68°F)] |
CVVT Oil Control Valve (OCV)
- Specification
CVVT OIL CONTROL VALVE SPECIFICATIONS CHART
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 6.9 ~ 7.9 [20°C (68°F)] |
Ignition Coil
- Type: Stick type
- Specification
IGNITION COIL SPECIFICATIONS CHART
| Item | Specification |
|---|---|
| 1st Coil Resistance (Ω) | 0.62 ± 10[20°C (68°F)] |
| 2nd Coil Resistance (kΩ) | 7.0 ± 15[20°C (68°F)] |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.