DTC Information: DTC Detecting Condition

2014 Hyundai Santa Fe XL PremiumSECTION DTC Detecting Condition
Item Detecting Condition Possible cause
DTC Strategy
  • Signal check, low
  1. Poor Connection
  2. Open or short to ground in power circuit
  3. Short to ground in signal circuit
  4. Fuel rail pressure sensor
  5. PCM
Enable Conditions
  • IG ON
Threshold value
  • Sensor voltage < 0.4 V
Diagnosis Time
  • 2.5 sec.
MIL On Condition
  • 2 Drive Cycles
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.