SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014SANTA FE XL PREMIUMREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM DIAGNOSIS (1 OF 3)DTC P0113: INTAKE AIR TEMPERATURE SENSOR 1 CIRCUIT HIGH INPUTDTC INFORMATIONDTC DETECTING CONDITION
2014 Hyundai Santa Fe XL Premium

DTC Information: DTC Detecting Condition

2014 Hyundai Santa Fe XL PremiumSECTION DTC Detecting Condition
Item Detecting Condition Possible Cause
DTC Strategy
  • This code detects a continuous short to high in either the signal circuit or the sensor
  1. Poor connection
  2. Open or short to battery in harness
  3. Open in ground harness
  4. IATS
  5. PCM
Enable Conditions
  • Engine running state
  • No Vehicle speed sensor fault
  • No ECTS fault
  • No MAFS fault
  • Intake airflow less than 15 g/s
  • Vehicle speed slower than 25kph (9.3mph)
  • Engine coolant temperature greater than 50°C (122°F)
Threshold value
  • Intake air temperature sensor's voltage greater than 4.9V
Diagnosis Time
  • Continuous (More than 10 seconds failure for every 20 seconds test)
MIL On Condition
  • 2 Driving Cycles
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.